UHD - USRP-E1X0 Series Application Notes

Table of Contents

Comparative features list

Specify a Non-standard Image

UHD will automatically select the USRP-Embedded FPGA image from the installed images package. The FPGA image selection can be overridden with the --fpga= device address parameter.

Example device address string representations to specify non-standard FPGA image:

fpga=usrp_e100_custom.bin

Changing the Master Clock Rate

The master clock rate of the USRP-Embedded feeds both the FPGA DSP and the codec chip. Hundreds of rates between 32MHz and 64MHz are available. A few notable rates are:

Set 61.44MHz - uses external VCXO

To use the 61.44MHz clock rate with the USRP-Embedded, two jumpers must be moved on the device.

  • J16 is a two pin header; remove the jumper (or leave it on pin1 only).
  • J15 is a three pin header; move the jumper to (pin1, pin2).

Note: See instructions below to communicate the desired clock rate UHD.

Set other rates - uses internal VCO

To use other clock rates, the jumpers will need to be in the default position.

  • J16 is a two pin header; move the jumper to (pin1, pin2).
  • J15 is a three pin header; move the jumper to (pin2, pin3).

To communicate the desired clock rate into UHD, specify the a special device address argument, where the key is master_clock_rate and the value is a rate in Hz. Example:

uhd_usrp_probe --args="master_clock_rate=52e6"

Clock Synchronization

Ref Clock - 10MHz

The E1xx has a 10MHz TCXO which can be used to discipline the flexible clocking by selecting REF_INT for the clock_config_t.

Alternately, an external 10MHz reference clock can be supplied by soldering a connector.

  • Connector J10 (REF_IN) needs MCX connector WM5541-ND or similar.
  • Square wave will offer the best phase noise performance, but sinusoid is acceptable.
  • Power level: 0 to 15dBm
  • Select REF_SMA in clock_config_t.

PPS - Pulse Per Second

An exteral PPS signal for timestamp synchronization can be supplied by soldering a connector.

  • Connector J13 (PPS) needs MCX connector WM5541-ND or similar.
  • Requires a square wave signal.
  • Amplitude: 3.3 to 5Vpp

Test the PPS input with the following app:

  • <args are device address arguments (optional if only one USRP is on your machine).
cd <install-path>/share/uhd/examples
./test_pps_input --args=<args>

Internal GPSDO

Please see the Internal GPSDO Application Notes for information on configuring and using the internal GPSDO.

UHD will always try to detect an installed GPSDO at runtime. There is not a special EEPROM value to burn for GPSDO detection.

Hardware Setup Notes

Front panel LEDs

The LEDs on the front panel can be useful in debugging hardware and software issues. The LEDs reveal the following about the state of the device:

  • LED A: transmitting
  • LED B: PPS signal
  • LED C: receiving
  • LED D: fpga loaded
  • LED E: reference lock
  • LED F: board power

Miscellaneous

Available Sensors

The following sensors are available; they can be queried through the API.

  • ref_locked: clock reference locked (internal/external)
  • other sensors are added when the GPSDO is enabled